AEM external Peak & Hold BMW Injector Driver module allows ECU's that have a saturated injector drive circuit to trigger low impedance injectors with a true 4/1 Peak & Hold injector drive circuit.

AEM's Peak & Hold Injector Driver for 3 series BMW contains 10 independent injector drive channels. Each channel supplies full battery voltage to a fuel injector for rapid current rise, in order to produce positive injector opening. When load current reaches 4.1A (amps), the injector driver reduces the load current to 1.1A and operates as a constant current source. This condition holds the injector open, and reduces system power dissipation. If the current fails to reach 4.1A within 5mS, the driver module automatically reduces the load current to 1.1A.

Installation ob BMW is straightforward. Users simply hook the injector trigger wires from BMW ECU to the module, and then hook the output wires from the module to your injectors. Any number of channels can be used from one to 10.

• ·      For high-output engines that have exceeded the capacity of high-impedance injectors
• ·      Includes 10 independent injector drive channels for any engine up to V10
• ·      Complete wiring system included
• ·      Operating Voltage: 8-18 volts, negative ground
• ·      RPM Capability: Unlimited
• ·      Injector Triggers: 10
• ·      Trigger Waveform: Output is activated when input trigger is grounded
• ·      Trigger Impedance: 220 Ohm input impedance, pulled to 12V (60 mA draw)
• ·      Injector Outputs: 10
• ·      Output Current High: 4.15A Peak, Typical
• ·      Output Current Low: 1.15A Sustain, Typical
• ·      Peak Current Timeout: 5mS
• ·      Size: 5.5"L x 4.6"W x 1.4"H
• ·      Weight: 2.7 Lbs
• ·      Over Temperature Shutdown: 115C (Nominal)

Inspection

Buyer shall inspect and reconcile all inbound shipments from Alle46Parts.com within seven (7) working days. Claims for shortages or damaged merchandise must be submitted to Alle46Parts.com no more than ten (14) working days following Buyer's receipt of shipment.

Returns; Defective and Damaged Merchandise

Defective and freight damaged merchandise (but only where Alle46Parts.com is providing shipment) may be returned to Alle46Parts.com for full credit, but only upon verification by Alle46Parts.com of such defect or damage. A Returned Merchandise Authorization ("RMA") form must be filled out by the Buyer and Approved by Alle46Parts.com. Credit will be issued to Buyer upon receipt of the RMA form and the claim approval from the freight company.

Returns; Exchanges; Good Merchandise

Returns of good merchandise may be accepted by Alle46Parts.com in its sole discretion under the following conditions:

1.      Return/Exchange of merchandise in totally re-saleable condition, without markings on the original packaging will be restricted to extraordinary circumstances with prior approval from Alle46Parts.com. Accepted return will be assessed a 20% restocking charge.

2.      Return/Exchange of merchandise in packaging that has been marked, relabeled or otherwise defaced will be restricted to extraordinary circumstances with prior approval from your Alle46Parts.com. Accepted return will be assessed a 30% restocking charge, except that Alle46Parts.com merchandise returned in packaging that has been marked, relabeled or otherwise defaced will be subject to a 40% restocking charge. Returned part number shall not exceed 15% of total annual purchase quantities.

3.      Merchandise on sales promotion or inventory packages may not be returned for credit.

4.      Buyer must pay all return transportation charges.

5.      Buyer must obtain and complete an RMA form, issued by Alle46Parts.com, for any good merchandise return or exchanges.

6.      Returns/Exchanges will not be accepted under any circumstances after 15 calendar days after the ship date indicated by Alle46Parts.com.